Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing Wiper Motor from Fiat Panda

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Windshield wipers

Remove the cover caps and then unscrew the screws that secure the wipers using a 13 mm spanner. Detach the wipers, then unscrew the three screws that secure them to the bar below, as shown in the video, allowing you to remove the black protective plastic. Unscrew the two 10 mm screws that secure the wiper motor's supporting structure, and disconnect the connector by prying the tab with a small flat screwdriver. Remove the motor and install the new one, proceeding in reverse order. It is advisable to replace the motor as soon as you notice it is not functioning, before too much water drains from the circuit, which could cause short circuits and damage to the electrical components under the bonnet.

Updated on 2 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Windscreen Wiper Motor from a Fiat Panda
How to Remove the Front Windscreen Wiper Motor from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Start by opening the bonnet of your Fiat Panda. Then, remove the front wipers by unscrewing their mounting bolts. Once done, unscrew the screws and b…
How to Dismantle the Rear Wiper Motor of the Fiat Panda 4x4 (141)
How to Dismantle the Rear Wiper Motor of the Fiat Panda 4x4 (141)
Fiat Panda (1980-2003 / 141, MK 1) In this video, you will see the steps that will allow you to dismantle and replace the rear wiper motor of the first series Fiat Panda 4x4, version 1…
Removing the wiper motor and arm on a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) In this video, you will see how to remove and replace the arm and motor of the front wipers on a second-generation Fiat Panda. First, open and lift t…

    Frequently Asked Questions

    • Panda 2012-2026 - Where is the Fiat Panda wiper fluid reservoir located? Read answer

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos