Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Third Brake Light Bulb on Fiat Bravo

Model: Fiat Bravo Bravo 2 - Years 2007-2014
Part:

Open the boot lid and, using a small flat screwdriver or a plastic wedge, remove the rear cover of the central stop light by levering in the gaps and extracting it. With the same flat screwdriver, lever on the tabs next to the bulbs to free the lamp. Close the boot lid and you will notice that the light has slightly come out of its housing: extract it without bending it and disconnect the connector. Release the black housing where the bulbs are fixed by separating it from the red cover: at this point, it is easy to extract the bulbs and replace them.

Updated on 4 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Stop Light Bulb on the Bravo
How to Replace the Stop Light Bulb on the Bravo
Fiat Bravo (2007-2014 / Bravo 2) Want to replace the third brake light or the bulbs/LEDs? Remove the light from inside the tailgate for replacement. Here's how to remove the light on…
How to Remove the Rear Light on a Fiat Bravo
How to Remove the Rear Light on a Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) Want to remove the rear light on your Fiat Bravo? Let’s see how to proceed with the disassembly in this video. Open the boot lid, unscrew the screws …
How to Remove the Third Brake Light of a Fiat Bravo
How to Remove the Third Brake Light of a Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) Watch this video to learn how to remove the third brake light of a Fiat Bravo. First, remove the plastic cover using a screwdriver (located at the ba…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos