Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Cabin Fan from a Fiat Panda 169

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Blower motor

In this video tutorial, you will see how to remove the cabin fan from a Fiat Panda 169. First, get inside the car and remove the plastic side panel next to the driver's pedals; then disconnect the electrical connector by pressing the tab, and remove the 5.5 mm screw that secures the fan. At this point, simply rotate and remove it from the car, as shown in the video. Now, replace the old fan with the new one (if it is not working) and reassemble everything by following the reverse procedure!

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Heating Fan from a Fiat Panda
How to Remove the Heating Fan from a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) The heating fan in a Fiat Panda is located above the pedals. Before you can begin, you need to remove the relevant cover. Start by disconnecting the …
How to Replace the Cabin Fan Fuse on a Fiat Panda
How to Replace the Cabin Fan Fuse on a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before you begin, open the front bonnet of your Fiat Panda. The cabin fan fuse is located inside the fuse box. The fuse box is situated within the en…
Replacing the Fan on Fiat Panda 169
Replacing the Fan on Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) Disconnect the battery before starting. The fan is located near the pedal area, in a rather awkward position, so you will need to remove the lower co…

    Frequently Asked Questions

    • Panda 2003-2012 - Where is the interior blower resistor on the Fiat Panda? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos