Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Seatbelts on a Fiat 500

Model: Fiat 500 312 - Years 2007-2021

In this video, you will see the steps to remove the front seatbelts from a Fiat 500, following the instructions provided below. First, open the doors and start by removing the lower plastic trim by unscrewing the securing screws; then remove the side pillar and the entire rear plastic panel, prising off the sides as shown in the video. At this point, disconnect the electrical connector of the pretensioner and unscrew the securing screws of the pretensioner to remove the entire piece along with the seatbelt!

Updated on 14 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the rear panel of the Fiat 500?
How to remove the rear panel of the Fiat 500?
Fiat 500 (2007-2021 / 312) To replace the rear panel of the Fiat 500, fully lower the front seats for easier access to the rear area. Here, detach the covering panels of the pi…
How to remove the seat belt of the Fiat 500
How to remove the seat belt of the Fiat 500
Fiat 500 (2007-2024 / 312) Below we will see the main instructions that will allow us to disassemble and replace the seat belt of the Fiat 500. First of all, we open the front …
Removing the Rear Seats of the Fiat 500 Abarth
Removing the Rear Seats of the Fiat 500 Abarth
Fiat 500 (2007-2021 / ) In this video tutorial, follow the main steps to remove the rear seats of the Fiat 500 Abarth, as outlined below. First, open the boot and start by r…

    Frequently Asked Questions

    • 500 2007-2022 - Where is the USB port fuse located on a Fiat 500? Read answer
    • 500 2007-2024 - What happens when the "uconnect" on Fiat 500 expires? Read answer
    • 500 2007-2024 - Where is the jack on the Fiat 500? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos