|
Do it yourself
| |||
| ||||
How to Replace the Window Regulator Motor on the Fiat Grande Punto
Model: Fiat Punto
MK 3, Punto EVO, 199, Grandepunto
- Years 2005-2018
This guide shows how to replace the motor and guide of the window regulator on the Fiat Grande Punto. Remove the three screws securing the panel, located in the handle area and under the armrest. Using a star screwdriver, unscrew the screws at the bottom of the door; remove the panel by pulling it from the bottom. Disconnect the wires and electrical connectors from behind the panel and remove it. Secure the glass with adhesive tape. Cut the soundproofing sheet from inside the door. Disconnect the power supply of the window regulator and remove the glass locking pin, then unscrew the three screws securing the window regulator. Slide the assembly out through the left hole in the door and replace it with the new spare part. Reposition it and secure it in place. Tighten the locking screws and the glass retaining pin. Reassemble all the removed elements and check the correct operation of the window.
Updated on 28 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Fiat Punto
(2005-2018 /
MK 3, Punto EVO, 199, Grandepunto )
In this guide, learn the steps to remove the front door panel and window regulator motor on the Fiat Grande Punto, as well as the Punto Evo. First, o…
Fiat Punto
(2005-2018 /
MK 3, Punto EVO, 199, Grandepunto )
Do you want to remove the window regulator motor from the rear door on a Fiat Grande Punto? First, use a plastic lever to remove the door trim pieces…
Fiat Punto
(2005-2018 /
MK 3, Punto EVO, 199, Grandepunto )
Replace the window regulator on a Fiat Grande Punto? Remove the door panel to access the window regulator motor. Use a lever to remove the manual win…
Other guides you may be interested in
|
Where is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.612
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |