Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Bumper on the Classic Fiat 500

Model: Fiat 500 Epoca - Years 1957-1975
Part: Front bumper

In this video tutorial, you will see step-by-step instructions for removing and replacing the front bumper of the classic Fiat 500 L. First, open the front compartment and start by removing the indicator bulbs found on the sides by pulling the electrical connector and unscrewing the nut at the base; then use a cross-head screwdriver to unscrew the screws of the front lights to remove them, as illustrated in the video. At this point, use a socket spanner to unscrew the screws located under the bumper for final removal!

Updated on 8 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Fit the Front Bumper on a Classic Fiat 500
How to Fit the Front Bumper on a Classic Fiat 500
Fiat 500 (1957-1975 / Epoca) Fitting the bumper on a classic 500 is really simple as there are only two screws with nuts and washers to install, along with the spacer and gasket.…
Removing the Plastics from the Bumper of the Fiat 500
Removing the Plastics from the Bumper of the Fiat 500
Fiat 500 (2007-2021 / 312) How to remove the front bumper of the Fiat 500 to replace it or to take off the parts. Lift the bonnet and secure it, raise the car on a jack to acce…
How to Remove the Engine from the Classic Fiat 500
How to Remove the Engine from the Classic Fiat 500
Fiat 500 (1957-1975 / Epoca) In today's video tutorial, you will see the main steps needed to remove the engine from the body of the Classic Fiat 500. First, open the rear bonnet…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos