Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fit the Front Bumper on a Classic Fiat 500

Model: Fiat 500 Epoca - Years: 1957, 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968
Part: Body

See other generations:
Video tutorial

Fitting the bumper on a classic 500 is really simple as there are only two screws with nuts and washers to install, along with the spacer and gasket. This applies if it is an "R" version.

If it is an "L" version, tubular spacers also need to be fitted, but this is not difficult, as there are still only two screws and spacers with gaskets that need to be secured to the bumper. Then attach the tubular to the body from underneath and the bumper to the car. Hold it in place with a knee.

Under the body, you will find two holes to support the screws for the tubular. Do not tighten the screws fully straight away, as you will need to find the correct alignment.


Updated on 7 August 2026 by ScegliAuto


Related tutorials

How to Remove the Bumper on the Classic Fiat 500
How to Remove the Bumper on the Classic Fiat 500
Fiat 500 (1957-1975 / Epoca) In this video tutorial, you will see step-by-step instructions for removing and replacing the front bumper of the classic Fiat 500 L. First, open the…
How to install the door panel of the 1966 Fiat 500
How to install the door panel of the 1966 Fiat 500
Fiat 500 (1957-1975 / Epoca) Installing the front door panel on a vintage 1966 Fiat 500 is a simple and quick operation to perform independently. We position the brush on the doo…
Fitting Front Bumper on Fiat 500
Fitting Front Bumper on Fiat 500
Fiat 500 (2012-2023 / 500 L) In this video tutorial, you will learn how to fit the front bumper of a Fiat 500. After purchasing the new bumper or previously removing the old one …

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos