Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Blue Fiat Logo with the Red Fiat Logo on the Panda 169

Model: Fiat Panda 169, MK 2 - Years 2003-2012
Part: Manufacturer emblem

To replace the old blue Fiat logo on the Panda with the newer red one, simply remove the old logo using a small flathead screwdriver or a heat gun. Then, carefully remove any residual adhesive with a degreaser or a craft knife blade; in any case, the surface must be perfectly clean, and the rubber pads must also be removed. The surface should be completely smooth. The red Fiat logo, as shown in the photo, can be found on Amazon for £16.80. After that, just stick it on, and you're done.

Updated on 11 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Logo on a Fiat Panda
How to Replace the Logo on a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) In today's video, discover how to replace the logo on a Fiat Panda 169. Specifically, how to swap the original blue logo for the post-2007 red one. F…
How to Replace the "Fiat" Logo on the Fiat Panda?
How to Replace the "Fiat" Logo on the Fiat Panda?
Fiat Panda (2012-2026 / 319, MK 3) To remove and replace the trim with the "Fiat" logo both front and rear, follow these steps: the logo is fixed with adhesive, so heat the logo using …
How to Dismantle the Key of a Fiat Panda
How to Dismantle the Key of a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) In today's video, see how to dismantle the remote key of the Fiat Panda 169 to replace its worn casing. Start by removing the Fiat logo using a screw…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos