Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Oil Pressure Sensor on the Fiat Panda

Model: Fiat Panda 169, MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012

See other generations:
Video tutorial

Today, in this video tutorial, learn how to remove and replace the engine oil pressure sensor and the crankshaft speed sensor on the Fiat Panda. First, lift the vehicle to access the oil pressure sensor; then remove the front wheel arch liner and disconnect its electrical connector, as shown in the video.

Next, unscrew the fixing screw and use a 21 mm socket spanner to unscrew and remove the oil sensor, replacing it with the new one; finally, reassemble everything!


Updated on 16 June 2026 by ScegliAuto


Related tutorials

How to Clean the MAP Air Pressure Sensor on a Fiat Panda 169
How to Clean the MAP Air Pressure Sensor on a Fiat Panda 169
Fiat Panda (2003-2012 / 169, MK 2) In this short video tutorial, you will see how to remove and clean the MAP air pressure sensor on a Fiat Panda 169. Start by opening the car's bonnet…
Removing Engine RPM Sensor on Fiat Panda
Removing Engine RPM Sensor on Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) In this video tutorial, you will learn how to remove the engine RPM sensor from a Fiat Panda, specifically the 4X4 model. First, remove the front whe…
How to Replace the Crankshaft Position Sensor on a Fiat Panda
How to Replace the Crankshaft Position Sensor on a Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) Before starting, open the bonnet of your Fiat Panda. Begin by lifting the front of the car. Then, unclip the connector securing the crankshaft positi…

Other guides you may be interested in

    Frequently Asked Questions

    • Panda 2003-2012 - Where is the fuel filter located on the Fiat Panda 1.2 169? Read answer

How to Activate the Disabled TRC on the Toyota Yaris?

As the video clearly shows, disabling or activating the traction control (TRC or ESP) on the Toyota Yaris is very simple. By default, the traction system activates every time the vehicle is started. To disable it, simply press the button depicting a skidding car located in the centre of the vehicle where the controls are, such as the hazard lights and the radio, but near the handbrake. Once disabled, the TRC off light will illuminate on the dashboard. To reactivate it, just press the same button again.

Watch the video!


by ScegliAuto

More videos