Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to replace the dipped beam lights on a Fiat Panda

Fiat Panda - Video tutorial

Model: Fiat Panda MK 3, 319 - Years 2012-2023
Part: Headlight bulb
Operation: How to replace the dipped beam lights on a Fiat Panda

Thanks to this video tutorial, we can see how to replace the low beam bulbs on a third generation Fiat Panda, model produced from 2012 to 2022. First we have to open the bonnet to access the rear part of the headlight and then we need to remove the rubber protection of the bulb. Once this is done, remove the dipped beam lock by pushing it downwards to be able to remove the bulb holder with the bulb to be changed, then replace it and reassemble everything following the procedure in reverse. The bulbs required for this vehicle are H4.


Posted on 22 November 2022 by ScegliAuto

    Frequently Asked Questions

    • Panda 2003-2012 - What to do when the low beams of the Fiat Panda 169 do not work? Read Answer
    • Panda 2012-2021 - Where are the parking lights located in the Fiat Panda? Read Answer
    • Panda 2012-2023 - How to change the headlight bulb in Fiat Panda? Read Answer
    • Panda 2012-2023 - How can I change the sidelight bulbs on my 2013 Fiat Panda? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos