Do it yourself
Frequently asked questions about cars and motorcycles

Lifting and Changing Tyres on the Fiat 500X

Model: Fiat 500 500 X - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022
Part: Wheel

See other generations:
Video tutorial

In this video, learn how to lift and change the tyres on a Fiat 500X: first, ensure you are parked on a solid, flat surface, away from traffic, avoiding icy and slippery areas. Also, make sure the hazard lights are on, the ignition is off, the handbrake is engaged, and no one is inside the vehicle.

If available, the jack, tools for changing the tyre, and the spare wheel are located in the boot; remove the securing device holding the spare wheel in place. It is a good idea to block the wheel diagonally opposite to the one you are changing.

Start by removing the centre cap covering the main wheel bolt, then loosen the bolts without removing them while the wheel is still on the ground. The front and rear lifting positions are indicated by triangular sections on the vehicle, and that is where you should place the jack, lifting the vehicle slightly off the ground.

Remove the wheel and fit the spare, tightening the bolts slightly. Lower the vehicle and remove the jack.

When the vehicle is on the ground, tighten the bolts.


Updated on 1 September 2026 by ScegliAuto


Related tutorials

Fiat 500 (2014-2022 / 500 X) In order to reset the tire pressure warning light of the Fiat 500X, you will need to first check the correct tire pressure values and inflate the tir…
Fiat 500 (2014-2022 / 500 X) To reset the tyre pressure warning light on the Fiat 500X, first inflate all the tyres to the recommended pressure value, which is indicated on the s…
Fiat 500 (2014-2022 / 500 X) Follow these simple instructions to reset the tyre pressure monitoring system (TPMS) light on a Fiat 500X; before performing the reset, ensure that a…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos