Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the starter motor on a Fiat Doblo

Model: Fiat Doblo 223, MK 1, Doblo 1 - Years 2000-2009
Part: Starter motor

In this video we can see the entire operation necessary to replace the starter motor on a Fiat Doblo, first generation model produced from 2000 to 2009 with a 1.9 JTD engine. So let's start by opening the hood of the car and then removing the battery along with its housing as shown in the video. Under the battery we will find the starter motor, so we continue the procedure by disconnecting its two connectors and then using a 10mm socket wrench to unscrew the three screws holding the starter motor in place. Once this is done, we can remove the old starter motor and replace it with a new one following the reverse procedure.

Posted on 12 July 2024 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the starter motor of the Fiat Doblò
Replacement of the starter motor of the Fiat Doblò
Fiat Doblo (2000-2009 / 223, MK 1, Doblo 1) In this guide, we will see the disassembly and replacement instructions for the starter motor of the Fiat Doblò. First, lift the vehicle and locate t…
Replacing the starter motor on a Fiat Doblo
Replacing the starter motor on a Fiat Doblo
Fiat Doblo (2000-2009 / 223, MK 1, Doblo 1) Replacing the broken starter motor on a Fit Doblo, let's see how to disassemble it. We open the front hood, remove the battery (we use a socket wrenc…
Change to Fiat Doblo battery
Change to Fiat Doblo battery
Fiat Doblo (2000-2009 / 223, MK 1, Doblo 1) Is the power supply battery of the Fiat Doblo to be replaced? Let's see how it disassembles. We open the car door and pull up the engine compartment …

Other guides you may be interested in

    Frequently Asked Questions

    • Doblo 2000-2009 - Where is the starter motor of the Fiat Doblò located? Read answer

How to Remove the Fuel Pump on Toyota Verso

Let's see how to remove the fuel pump on a Toyota Verso. First, disconnect the battery cables, then remove the rear seat from the car. You will find various wiring and a metal piece with screws; unscrew the securing screws of the metal cap and remove it. Wrap the entire perimeter of the metal panel with paper or an absorbent cloth, then, using a screwdriver and hammer, unscrew the large bolt around the pump. Disconnect the power terminals and the fluid circulation tubes. Extract the fuel pump. To reassemble, proceed in reverse order.

Watch the video!


by ScegliAuto

More videos