Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where is the spare tire of the Ford Escape located?

Model: Ford Escape MK 3 - Years 2013-2019
Part: Wheel

The spare wheel on a Ford Escape vehicle is located under the trunk. To use the spare wheel in case of a flat tire, we must open the trunk, remove the lower cover, and lift the red lever to release the spare wheel to the ground. Remove the nut that secures the wheel and proceed with the replacement. We remind you that it is not allowed to drive for a long time with the spare wheel, it is always best to go to a tire shop as soon as possible to replace the main wheel. Instructions on how to replace the wheel and access the spare wheel are included in the vehicle's user manual and maintenance manual.

Posted on 6 July 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the wheel with the spare one of the Ford Escape
How to replace the wheel with the spare one of the Ford Escape
Ford Escape (2020-2026 / MK 4) Let's see the instructions for disassembling and replacing the wheel with the spare one of the Ford Escape, in simple steps. First of all, we open th…
Access to the spare tire of a 2008 Ford Escape
Access to the spare tire of a 2008 Ford Escape
Ford Escape (2008-2012 / MK 2) The video shows how to access the spare wheel of a 2008 Ford Escape. It's a very simple operation that can easily be done by yourself at any time. Op…
Replacement of the battery of a Ford Escape with a 48 AGM group
Replacement of the battery of a Ford Escape with a 48 AGM group
Ford Escape (2020-2026 / MK 4) In this video, we can see how the owner of this Ford Escape replaced his 12-volt battery, which often went dead, with a 48-volt AGM group. The batter…

How to Replace the Boot Compartment Light Bulb on a Peugeot 208

If you want to improve visibility inside the boot compartment, it is recommended to replace the original incandescent bulb with a LED type (T10 fitting); once the rear hatch is opened, locate the bulb holder positioned on the side, near the shock absorber dome, where the plastic grille is located. Then, lever the retaining tab to extract the bulb holder, disconnect the power connector, and remove the old bulb to replace it with the LED one; reconnect the power, check the correct operation of the bulb (if not, rotate it 180°), and reposition the bulb holder in its place.

Watch the video!


by ScegliAuto

More videos