Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the wheel with the spare one of the Ford Escape

Model: Ford Escape MK 4 - Years 2020-2026
Part: Wheel

Let's see the instructions for disassembling and replacing the wheel with the spare one of the Ford Escape, in simple steps. First of all, we open the rear door of the trunk and start removing the spare wheel from under the floor, unscrewing the fixing screws; then we take out the entire wheel replacement kit, lifting the car with the jack. At this point, we unscrew the wheel bolts to remove it, installing the spare one; we tighten the bolts in a crossed manner and place the kit back under the trunk compartment, along with the old replaced wheel.

Posted on 16 September 2024 by ScegliAuto

Video tutorial

Related tutorials

Where is the spare tire of the Ford Escape located?
Where is the spare tire of the Ford Escape located?
Ford Escape (2013-2019 / MK 3) The spare wheel on a Ford Escape vehicle is located under the trunk. To use the spare wheel in case of a flat tire, we must open the trunk, remove th…
Accessing the Spare Tire of a 2008 Ford Escape
Accessing the Spare Tire of a 2008 Ford Escape
Ford Escape (2008-2012 / MK 2) The video shows how to access the spare tire of a 2008 Ford Escape. This is a very simple operation that can be done easily by yourself at any time. …
Replacement of the battery of a Ford Escape with a 48 AGM group
Replacement of the battery of a Ford Escape with a 48 AGM group
Ford Escape (2020-2026 / MK 4) In this video, we can see how the owner of this Ford Escape replaced his 12-volt battery, which often went dead, with a 48-volt AGM group. The batter…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos