Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Driveshaft on a Ford Fiesta

Model: Ford Fiesta MK V, MK 5, Fiesta 5 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008
Part: Axle shaft

See other generations:
Video tutorial

Replace the damaged CV joint on the Ford Fiesta. Lift the vehicle to a comfortable height for working.

Remove the wheel bolts using a socket or air impact wrench, then take the wheel off. Next, start loosening the bolts under the wheel hub with a socket wrench. Remove the bolt located under the hub of the bar. Pull the arm around the joint with your hands (use a hammer to tap it if necessary).

Fit the new joint along with the new boot (after removing the old one). Connect the joint to the hub and then refit the wheel using the securing bolts.


Updated on 17 March 2026 by ScegliAuto


Related tutorials

How to Replace the CV Boot of the Ford Fiesta?
How to Replace the CV Boot of the Ford Fiesta?
Ford Fiesta (2008-2017 / Fiesta 6, MK VI, MK 6) To replace the CV boot of the Ford Fiesta, lift the corresponding wheel with a jack so that it is not in contact with the ground: then unscrew the bo…
How and when to replace the timing belt of the Ford Fiesta 1.0 Ecoboost
How and when to replace the timing belt of the Ford Fiesta 1.0 Ecoboost
Ford Fiesta (2017-2023 / MK 7, MK VII, Fiesta 7) In this guide, we will see the instructions for disassembling and replacing the timing belt of the Ford Fiesta 1.0 Ecoboost; on this type of engine, …
How to Remove the Driveshaft with the Gaiter on a Ford Fiesta
How to Remove the Driveshaft with the Gaiter on a Ford Fiesta
Ford Fiesta (2008-2017 / Fiesta 6, MK VI, MK 6) Learn how to remove the driveshaft with the gaiter on a Ford Fiesta. Position your car on a column lift: raise it to a comfortable height for working…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos