Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Ford Focus headlight removal

Ford Focus - Video tutorial

Model: Ford Focus MK 1 - Years 1998-2004
Part: Headlight
Operation: Ford Focus headlight removal

In this simple video tutorial we will see how to remove the headlight of a Ford Focus. We open the bonnet of the car and we go to unscrew the screws of the support bracket of the headlight, which we find laterally and at the bottom right: once all the screws have been removed, we begin to unhook the headlight very gently until it is extracted; finally unhook the electrical connector. At this point we can go to disassemble the bulbs, if necessary, or we can continue with the disassembly of the front bumper. To reassemble the light, simply apply the reverse procedure.


Posted on 28 December 2023 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - What causes the Ford Focus low beam headlight problem? Read Answer
    • Focus 2004-2011 - How much does it cost to replace the Ford Focus Mk2 low beam bulb? Read Answer
    • Focus 2018-2025 - How to reset errors and fault codes of a Ford Focus 2018? Read Answer
    • Focus 1998-2004 - How to remove the alternator belt of a Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos