Do it yourself
Frequently asked questions about cars and motorcycles

Removing the Half Shaft from a Ford Focus MK1

Model: Ford Focus MK 1 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Axle shaft

See other generations:
Video tutorial

Today, follow these steps to remove and replace the half shaft on a first series Ford Focus. First, lift the vehicle and remove the front wheel; then disconnect the suspension from the braking system by undoing the fixing pin. At this point, undo the hub bolt and pull it out from the half shaft using a sturdy lever; then lever the end to remove the front half shaft, as shown in the video.

Finally, replace it with the new one, following the video until the end!


Updated on 3 April 2026 by ScegliAuto


Related tutorials

Ford Focus (2011-2018 / MK 3) In this tutorial, learn how to remove and replace the front driveshaft on your Ford Focus by following the instructions below. First, lift the vehicl…
Ford Focus (1998-2004 / MK 1) Before you start, open the bonnet of your Ford Focus. Begin by unscrewing and removing the screws and bolts located around the perimeter of the bumpe…
Ford Focus (2004-2011 / MK 2, Focus 2) Before you can start, open the bonnet of your Ford Focus. Begin by unclipping and removing the upper engine cover. Next, unscrew and remove the bolts…

How to open the boot if it is stuck on a Mercedes B-Class?

On the Mercedes B-Class, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In this case, perform the emergency opening by following the simple procedure shown in this tutorial. First, unlock the locks with the remote control, then open the rear doors and, by operating the indicated lever, lower the backrest of the seat. Next, go inside the boot, locate the indicated gap, and manually unlock the lock using a small screwdriver.

Watch the video!


by ScegliAuto

More videos