|
Do it yourself
| |||
| ||||
Tightening the Handbrake on Ford Fiesta 2017
Model: Ford Fiesta
Fiesta 6, MK 6, MK VI
- Years 2008-2017
Except for cars with electronic devices, the operation of the handbrake on standard cars with a lever consists of a system of steel cables connected to calipers and drums that allow for their locking. The tension of the cables is controlled by the lever, which may loosen over time. It’s easy to tell; the lever will feel loose and very soft. To tighten the cables on a Ford Fiesta, here’s how to do it. The first step is to remove the centre console. There are no screws, so you will need to pull it out manually by moving it sideways to release the clips. The bolt to tighten is located at the base of the lever, at the front. You will now need a 10mm socket spanner to tighten the bolt just enough. Make two or three adjustments while tightening to find the right stiffness of the lever; over-tightening will keep the car braked.
Updated on 2 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Ford Fiesta
(2002-2008 /
Fiesta 5, MK 5, MK V)
This video shows how to adjust and remove the handbrake lever of a Ford Fiesta. Use a screwdriver to remove the cover under the armrest (if available…
Ford Fiesta
(2002-2008 /
Fiesta 5, MK 5, MK V)
The adjustment of the handbrake is performed using a nut located directly under the handbrake lever: pull the handbrake fully to access the adjustmen…
Ford Fiesta
(2017-2023 /
MK 7, MK VII, Fiesta 7)
Adjusting the handbrake on the Ford Fiesta Mk VII is done by acting on the central tensioner, accessible after removing the console. Lift the plastic…
Other guides you may be interested in |
Where is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.075
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
