Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where is the Engine RPM Sensor Located on a Ford Focus and How to Replace It?

Model: Ford Focus MK 1 - Years 1998-2004
Part: Crankshaft position sensor

This video shows where the crankshaft RPM sensor is located on a Ford Focus and how to proceed if you need to replace it. As shown, it is situated at the lower part of the engine, and to access it, you must lift the vehicle, taking all necessary precautions. Once done, remove the indicated plastic cover by unscrewing the relevant bolts, press the plastic clip of the connector, and disconnect it. Next, remove the two bolts with an 8mm spanner, extract the sensor from its housing, and fit the replacement by following the reverse procedure.

Updated on 15 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the engine oil pressure sensor located in the Ford Focus?
Where is the engine oil pressure sensor located in the Ford Focus?
Ford Focus (2004-2011 / MK 2, Focus 2) In this video, you can see where the engine oil pressure sensor is located in the Ford Focus. This component is crucial for the proper functioning of…
How to Change the Speed Sensor on a Ford Focus
How to Change the Speed Sensor on a Ford Focus
Ford Focus (1998-2004 / MK 1) This brief guide outlines the steps to remove and replace the speed sensor on a Ford Focus. First, locate the speed sensor on the engine block; this …
How to Fix High RPMs and Unstable Idle on the Ford Focus 1.6 MK1
Ford Focus (1998-2004 / MK 1) In this video tutorial, identify the cause of the malfunction of the idle actuator, which allows you to lower the idle appropriately and keep the eng…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos