Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How do you change the front bulbs of the Ford Focus?

Ford Focus - Video tutorial

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Light bulb
Operation: How do you change the front bulbs of the Ford Focus?

Thanks to this video, we can learn how to replace the front bulbs of the Ford Focus Mk2, which was on the market between 2004 and 2011. The procedure consists of the following steps: 1) release the front hood by pulling the appropriate lever from inside the cabin; 2) lift the hood; 3) unscrew the Torx screw and press on the two plastic clips shown in the video to remove the front headlight; 4) disconnect the electrical connector (not necessary, but allows for more comfortable work); 5) remove the rubber cap; 6) extract the bulb holder; 7) replace the burnt-out bulb and put everything back in place.


Posted on 8 October 2023 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - How to replace the sidelights bulb on the Ford Focus? Read Answer
    • Focus 2018-2025 - How much does the position light bulb cost for the Ford Focus? Read Answer
    • Focus 1998-2004 - What to do if the Ford Focus hood light does not come on? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos