Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Dipped Beam and Position Bulbs

Model: Ford Focus MK 1 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Light bulb

See other generations:
Video tutorial

To replace the dipped beam and position bulb in the Ford Focus, go behind the headlamp, unclip the cover by gently pulling it down, lower the cover and remove it; after removing the cover, disconnect the electrical connector of the bulb, unclip the bulb from the headlamp and take it out, remembering the orientation; once the bulb is removed, insert the new bulb into the headlamp in the same position as the old one, refit the clip that holds it in place, reconnect the electrical connector, and move on to the position bulbs; to remove the position bulbs, pull out the bulb holder, disconnect the bulb from the holder, take the new bulb, reconnect it as the old one, and reinsert it into its socket; now check the correct operation, replace the cover behind the headlamp, and reconnect the clip that secures the cover.


Updated on 9 September 2026 by ScegliAuto


Related tutorials

Replacing the Dipped Beam Bulb on a Ford Focus
Replacing the Dipped Beam Bulb on a Ford Focus
Ford Focus (2011-2018 / MK 3) To replace the dipped beam bulb on your Ford Focus, first open the bonnet. Next, unscrew the two screws that hold the light in position, then remove …
Replacing Dipped Beam Bulbs on a Ford Focus 3
Replacing Dipped Beam Bulbs on a Ford Focus 3
Ford Focus (2011-2018 / MK 3) This short video guide shows the entire procedure necessary to replace the dipped beam bulbs on our third-generation Ford Focus, produced from 2011 t…
What is the Dipped Beam Relay in a Ford Focus?
What is the Dipped Beam Relay in a Ford Focus?
Ford Focus (1998-2004 / MK 1) If the dipped beam headlights on your Ford Focus have suddenly stopped working, and both the bulbs and fuses are in good condition, you can check the…

How to Reset the Tyre Light on a Toyota Aygo?

To reset the tyre light on a Toyota Aygo, start by locating the reset button, which is found in the glove compartment of the front passenger side. Turn on the car and ensure that the tyres are at the correct pressure. Then, press and hold the reset button for a few seconds until the tyre light either flashes or turns off, depending on the model. Release the button and wait for the reset procedure to complete. Restart your Toyota Aygo and check if the tyre light has turned off, indicating that the reset was successful.

Watch the video!


by ScegliAuto

More videos