Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Dipped Beam Bulbs on a Ford Focus 3

Model: Ford Focus MK 3 - Years 2011-2018
Part: Headlight bulb

This short video guide shows the entire procedure necessary to replace the dipped beam bulbs on our third-generation Ford Focus, produced from 2011 to 2018. First, remove the headlamp by unscrewing the two screws that hold it in place, then pull it out of its housing. Next, remove the rubber cover of the bulb as shown in the video. Once done, grasp and rotate the bulb counterclockwise a quarter turn to remove it from its socket. Finally, disconnect the old bulb from the connector and insert a new one, then reassemble everything by following the reverse procedure.

Updated on 9 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the low beam bulbs in the Ford Focus?
How to replace the low beam bulbs in the Ford Focus?
Ford Focus (2011-2018 / MK 3) In this tutorial we can see how to replace the low beam bulbs in the Ford Focus, an extremely simple and quick operation. First of all, make sure tha…
Replacing the Rocker Cover Gasket on a Ford Focus MK2 1.6 TDCi
Replacing the Rocker Cover Gasket on a Ford Focus MK2 1.6 TDCi
Ford Focus (2004-2011 / MK 2, Focus 2) In today's video, you will see instructions for removing and replacing the rocker cover gasket on a second-generation Ford Focus 1.6 TDCi. First, ope…
Replacing the Rear Brake Pads on Ford Focus
Replacing the Rear Brake Pads on Ford Focus
Ford Focus (2004-2011 / MK 2, Focus 2) Let's look at replacing the rear brake pads on a Ford Focus. Lift the car on a column lift to the desired height, then remove the wheel. Unscrew the …

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos