Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly and Replacement of the Driveshaft

Model: Honda Accord MK 5 - Years: 1993, 1994, 1995, 1996, 1997, 1998
Part: Axle shaft

See other generations:
Video tutorial

Before lifting the vehicle, straighten the deformation of the driveshaft nut at the hub (central position) and then unscrew it. Next, lift the vehicle, remove the wheel, and loosen the fastening pin of the wishbone ball joint at the hub so that you can extract the driveshaft from the hub itself.

At this point, extract the driveshaft from the gearbox using a large flat screwdriver as leverage.

Then install the new driveshaft (check that the number of notches on the wheel side joint is the same as the old one: this is important for the ABS sensor) by inserting it first from the gearbox side and then into the hub. Finally, tighten the central nut, deforming it in line with the groove, and refit the wishbone.


Updated on 4 February 2026 by ScegliAuto


Related tutorials

Replacement of Engine Oil and Oil Filter
Replacement of Engine Oil and Oil Filter
Honda Accord (2008-2013 / MK 8) Lift the vehicle on suitable car ramps. Position a suitable capacity container under the oil sump to collect the used oil, and unscrew the drain plug…
Replacement of Brake Discs and Callipers
Replacement of Brake Discs and Callipers
Honda Accord (2002-2007 / MK 7) Lift the vehicle on suitable car stands and remove the rear wheel; then disconnect the handbrake cable from the brake calliper and the oil pipe, ensu…
Removing the Timing Belt
Honda Accord (1998-2002 / MK 6) The timing belt is one of the most worn parts in a car; failing to replace it when necessary can have serious repercussions on the engine's health. A…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos