Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing Side Spoilers

Model: Honda Jazz MK 2 - Years 2008-2013
Part: Body

For the modification, obtain the original spoilers, then position the vehicle on a ramp and begin by removing the plastic protective caps from the existing holes on the sides. Attach paper templates to the newly exposed holes and mark the cutting points. Use a drill to make holes at the corners. Insert sound insulation into the passenger side panels. Install the metal support structure following the attached instructions. Mount the supports under the body and fit the spoilers over the supports through the newly made holes. Secure the spoilers to the supports by tightening the bolts located underneath them. Tighten the bolts well.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installation of Rear Spoiler
Installation of Rear Spoiler
Honda Jazz (2008-2013 / MK 2) To install the spoiler on the rear bumper, you first need to remove the bumper itself: it is recommended to lift the vehicle on a hydraulic lift to f…
How to install the cargo area cover on the Honda Jazz
How to install the cargo area cover on the Honda Jazz
Honda Jazz (2013-2019 / MK 3) In this video we can see how to install the cargo compartment cover on the Honda Jazz. It is a cover divided into two layers, convenient for storing …
Installation of Window Deflectors
Installation of Window Deflectors
Honda Jazz (2008-2013 / MK 2) Since the deflector is fixed using double-sided adhesive, it is very important to clean the edge of the seal along the door pillar thoroughly: use a …

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos