Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I10
    4. : How to remove the front door panel of the Hyundai I10

Hyundai I10 - Video tutorial

Model: Hyundai I10 MK 1, PA - Years 2007-2013
Part: Door panel
Operation: How to remove the front door panel of the Hyundai I10

Let's find out the necessary guide that will allow us to remove and replace the front door panel of the Hyundai I10. First we open the front door and begin to remove the plastic caps located on the panel, as well as on the opening handle and on the sides; then we go to unscrew the fixing screws that we find below, as shown in the video. At this point we lever the sides of the panel to detach and remove it, disconnecting the electrical connector of the window control panel; disconnect the handle cable and refit the door panel!


Posted on 23 September 2022 by ScegliAuto



How to open the fuel door of the Hyundai i10.
Hyundai I10 (2013-2020 / MK 2, IA) As you can see very well in the video, opening the fuel door (gasoline) of your Hyundai I10 car is very simple. Unlike other cars where you simply pr
How to disassemble the door panel in the Hyundai I10?
Hyundai I10 (2013-2020 / MK 2, IA) In this tutorial we can see how to disassemble the door panel in the Hyundai I10, an extremely simple and quick operation. First of all, we open the
How to remove the door panel in the Hyundai I10?
Hyundai I10 (2007-2013 / MK 1, PA) In the first Hyundai I10 model, the one produced between 2007 and 2013, the door panel is held in place with six screws. Two of these are located on

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos