Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Front Brake Pads and Machining Discs

Model: Hyundai Elantra MK 3, XD - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Brake pads

See other generations:
Video tutorial

When replacing the front brake pads, consider machining the discs to make the surface perfectly smooth and eliminate any surface scratches. This operation can only be performed if the remaining thickness of the discs allows it. Lift the vehicle to remove the wheel, brake caliper, caliper bracket, and then the disc.

After verifying that the disc thickness is within an acceptable range, have the disc machined and then reverse the process by installing a new set of pads. Pay close attention during the initial braking.


Updated on 20 February 2026 by ScegliAuto


Related tutorials

Replacement of Front Brake Pads
Replacement of Front Brake Pads
Hyundai Elantra (2006-2010 / MK 4, HD) Lift the vehicle on a hydraulic lift and remove the front wheel; then unscrew the retaining pins of the brake caliper located at the rear and remove …
Replacement of Rear Brake Discs
Replacement of Rear Brake Discs
Hyundai Elantra (2000-2006 / MK 3, XD) Lift the vehicle and apply suitable axle stands. Then remove the wheel and the brake caliper, which must be taken off along with the pads; also remov…
How to Replace Brake Discs
How to Replace Brake Discs
Hyundai Elantra (2000-2006 / MK 3, XD) This guide shows how to replace the brake discs on your car. They are crucial for the safety of the driver and passengers. First, turn the steering w…

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos