Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you locate the speed sensor position of the vehicle in an IVECO DAILY 35C10?

Model: IVECO Daily MK 3 - Years: 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006
Part: Crankshaft position sensor

See other generations:
Video tutorial

So, if you need to find the speed sensor on your Iveco Daily 35C10, be prepared to get your hands a little dirty! This sensor, also known as the VSS sensor, is usually located on the gearbox, near the output shaft. To locate it, follow the electronic odometer cable or look for a three-wire connector fixed with a screw.

It is a small component, but essential for managing speed and the speedometer. If you have difficulty seeing it, try looking under the van with a flashlight.

Once found, if you need to replace it, disconnect the connector, unscrew it, and install a new one. If you are not comfortable doing it yourself, definitely contact a trusted mechanic.


Posted on 30 September 2025 by ScegliAuto


Related tutorials

How to Increase the Idle on the Iveco Daily IV with Cruise Control
How to Increase the Idle on the Iveco Daily IV with Cruise Control
IVECO Daily (2006-2020 / MK 4) In this video, our YouTuber demonstrates a particular use of the cruise control on the Iveco Daily IV: we all know that by setting the cruise control…
Where is the Horn Fuse on an Iveco Daily?
IVECO Daily (1999-2006 / MK 3) To locate the horn fuse on an Iveco Daily, first identify which fuse box it is in. There are two fuse boxes on the Daily, and from this video, we can…
Fuse box diagram for an Iveco Daily
IVECO Daily Through this very short video tutorial, you can see the diagram of the main fuse box for an Iveco Daily, a model produced from 2000 to 2006. The diag…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos