Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to repair a fault in the turn signal switch of an Iveco Daily

Model: IVECO Daily MK 4 - Years 2006-2020
Part: Checks and maintenance

In this video we see how it was possible to repair the turn signal switch of an Iveco Daily. Our youtuber removed the component to take a look at it in order to reorganize the piece, but when he examined it, he saw that the welding joints on the switch were all loose. The switch still worked, but intermittently, precisely because of the poor quality of the welds. After cleaning it with a brake cleaner, he proceeded to weld it with a small tool and low melting point solder (in fact, if the board is overheated, the track can detach). Before reassembly, a little grease was applied.

Posted on 16 April 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you remove the bulb from the turn signal indicator of the external rearview mirror on the Iveco Daily?
How do you remove the bulb from the turn signal indicator of the external rearview mirror on the Iveco Daily?
IVECO Daily (2006-2020 / MK 4) The vehicle shown in the video is a Fiat Ducato, but since they are structurally very similar, we can consider this operational demonstration valid f…
How to Reset the Service Light on the Iveco Daily?
How to Reset the Service Light on the Iveco Daily?
IVECO Daily To reset the Service light on the Iveco Daily, press the accelerator pedal while the vehicle is completely off: while holding it down, turn the key i…
How do you repair the fan controls in an IVECO Daily III series?
How do you repair the fan controls in an IVECO Daily III series?
IVECO Daily (1999-2006 / MK 3) Repairing the fan controls in an IVECO Daily III series requires a few steps. First of all, turn off the engine and disconnect the battery for safety…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos