Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Brake Pads on Jeep Grand Cherokee

Model: Jeep Grand Cherokee WK, MK 3, WH - Years 2004-2010
Part: Brake pads

Loosen the wheel bolts of the affected wheel, lift the car, and completely unscrew them to remove the wheel. The brake caliper is secured by two bolts located at the rear, facing towards the centre of the car. Remove the two plastic covers over the bolts and unscrew them. Then, extract the small clip that holds the caliper closed, as shown in the video. Once removed, take out the old brake pads and insert the new ones; be careful, as these will obviously be thicker than the old, worn ones. Therefore, widen the pad seats before inserting them.

Updated on 10 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on a Jeep Grand Cherokee
How to Replace the Front Brake Pads on a Jeep Grand Cherokee
Jeep Grand Cherokee (1998-2004 / MK 2, WJ) To replace the front brake pads on a Jeep Grand Cherokee, lift the vehicle using a jack or ramp to access the bolts securing the corresponding front …
What is the radio code for a Jeep Grand Cherokee and how to enter it?
What is the radio code for a Jeep Grand Cherokee and how to enter it?
Jeep Grand Cherokee (1998-2004 / MK 2, WJ) After replacing the battery in your Jeep Grand Cherokee, the radio may reset and lock. To unlock it, you need to enter the unlock code. Start by sitt…
How to Reset the Oil Light on a Jeep Grand Cherokee
How to Reset the Oil Light on a Jeep Grand Cherokee
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) Before starting, sit in the driver's seat of your Jeep Grand Cherokee. Turn the key in the ignition switch without activating the instrument cluster.…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos