Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Compass
    4. : How to replace the headlight bulb on the 2018 Jeep Compass

Jeep Compass - Video tutorial

Model: Jeep Compass 552, MK 2 - Years 2016-2024
Part: Headlight bulb
Operation: How to replace the headlight bulb on the 2018 Jeep Compass

If you want to replace the headlight bulb of your Jeep Compass Mk2 (year 2018) but you don't know what steps to take then you just have to read the following mini guide carefully and put into practice everything that you will find described. First, park the car on a level surface and turn it off completely. Then lift the front bonnet of the car and remove the protective cap located inside the engine compartment. At this point, unscrew the malfunctioning bulb and replace it with the new one. Finally, put the cap back on correctly and you're done.


Posted on 11 December 2022 by ScegliAuto



How to replace the headlight bulb on a Jeep Compass
Jeep Compass (2006-2016 / MK 49, MK 1) Before we can begin, we will have to go and open the front hood of our Jeep Compass. So let's start by disconnecting the electrical connector connect
How do you replace the front headlight bulb of the Jeep Compass?
Jeep Compass (2016-2024 / 552, MK 2) The operation of replacing the headlight bulb on the Jeep Compass is done by loosening the screws that secure the inner cover of the fender in corres
Jeep Compass headlight bulb replacement
Jeep Compass (2016-2024 / 552, MK 2) Today we will see how to remove and replace the headlight bulb of a Jeep Compass. First of all, let's remove the mudguard screws from the affected si

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos