Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Third Brake Light Bulb on a Jeep Grand Cherokee

Model: Jeep Grand Cherokee WK2, MK 4 - Years 2010-2021
Part: Tail light

Today, in this video tutorial, you will learn how to remove and replace the third brake light and its bulbs on a Jeep Grand Cherokee. First, open the rear tailgate and start by removing the side plastic cover using a thin plastic lever; then unscrew the fixing screws of the third brake light using a ratchet spanner, as shown in the video. Now disconnect the electrical connector to remove the entire light unit, replacing the bulbs if necessary; then reassemble everything by following the reverse procedure!

Updated on 23 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Third Brake Light in a Jeep Grand Cherokee
How to Replace the Third Brake Light in a Jeep Grand Cherokee
Jeep Grand Cherokee (2004-2010 / WK, MK 3, WH) In this tutorial, you will see how to replace the third brake light in a Jeep Grand Cherokee, a very simple and quick operation. For this, you will o…
How to Replace the Rear Headlamp Bulb on a Jeep Grand Cherokee
How to Replace the Rear Headlamp Bulb on a Jeep Grand Cherokee
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) To replace the rear headlamp bulb, open the boot to access the two screws that secure the lamp near the boot seal. Once the two screws are loosened, …
How to Replace the Centre Console Bulb on a Jeep Grand Cherokee
How to Replace the Centre Console Bulb on a Jeep Grand Cherokee
Jeep Grand Cherokee (1998-2004 / MK 2, WJ) Before you begin, sit in the driver’s seat of your Jeep Grand Cherokee. Start by unclipping and removing the trim around the gear lever, using a thin…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos