Do it yourself
| ||||
|
Jeep Renegade - Video tutorial
Model: Jeep Renegade
BU, MK 1, 520
- Years 2014-2023 In this tutorial, we can see how to replace the fuel filter in the Jeep Renegade. For this operation, we will need to lift the car on a bridge or with a jack, taking all necessary precautions of course. Once this is done, move to the rear of the vehicle, locate the tank cover, and remove it. Then, unscrew the single bolt of the fixing clamp with a 10mm socket wrench and disconnect the two tubes by unlocking the yellow clips. At this point, we can remove the filter from the housing and install the replacement by following the reverse procedure.
Posted on 10 June 2023 by ScegliAuto
How do you open the fuel flap of the Jeep Renegade?
Jeep Renegade (2014-2023 / BU, MK 1, 520) To be able to open the fuel filler flap of the Jeep Renegade it is not necessary to press any button located inside the passenger compartment that al
How to reset the average fuel consumption indicator light on the Jeep Renegade.
Jeep Renegade (2014-2023 / BU, MK 1, 520) If you want to manually reset the indicator light that shows the average fuel consumption of your Jeep Renegade, then all you have to do is carefully
How to open the fuel flap in the Jeep Renegade
Jeep Renegade (2014-2023 / BU, MK 1, 520) In today's video we see how to open the fuel door of the Jeep Renegade, in case it is stuck. Precisely we see 3 different ways: - the first consists Other guides that may interest you |
How to reset the tire warning light on Toyota Yaris CrossTo reset the tire pressure warning light, first we check the pressure of all the wheels, then we turn on the instrument panel without turning on the car, we press the button with the arrow to the right until we go to the gear screen; with the arrow down we go to the word "vehicle settings" and press the "ok" button for a few seconds to confirm; with the arrow down we go to the writing "TPWS setting", press the "ok" button to confirm; with the arrow down we go to the wording "wheel identification and position", press the "ok" button for a few seconds to confirm; at this point the warning light will flash slowly 4 times and then it will stay on for about ten minutes, if after 10 minutes the warning light goes out the operation is finished and we can turn off the instrument panel (it may take a few kilometers for a total reset), otherwise, if the warning light does not go off, it is advisable to go to the assistance service. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.035
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |