Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Rear Spoiler Installation

Model: Kia Rio UB, MK 3 - Years 2011-2017
Part: Accessory kit

Obtain the appropriate spoiler for the vehicle. Clean the bodywork thoroughly with a mild solvent to allow for perfect adhesion of the double-sided tape. Remove part of the protective paper from the double-sided tape and position the spoiler in the correct place without pressing hard. Gently pull off the remaining protective backing from the double-sided tape without pressing on the spoiler to keep it perfectly in place. Once the protective backing is removed from one side, proceed with the other side until all of it is completely removed. Once all the protection is off, press firmly to ensure the double-sided tape adheres across the entire surface.

Updated on 8 February 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Instructions for Replacing Auxiliary Belts
Instructions for Replacing Auxiliary Belts
Kia Rio (2005-2011 / DE, MK 2) The vehicle model in question is equipped with two auxiliary belts, one dedicated to the power steering pump and the other that drives the alternator…
How to Replace the Timing Belt on Kia Rio
How to Replace the Timing Belt on Kia Rio
Kia Rio (2005-2011 / DE, MK 2) To replace the timing belt on the Kia Rio, open the bonnet to access the left side of the engine block. Here, you will locate the belt around the res…
Instructions for Replacing the Clutch Kit
Instructions for Replacing the Clutch Kit
Kia Rio (2000-2005 / DC, MK 1) It is recommended to carry out this repair only if you have good mechanical knowledge, as it requires disassembling the gearbox and installing the ki…

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos