Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Headlight Bulb on a KTM Duke 690

Model: Ktm Duke 690
Part: Headlight bulb

Video tutorial

In this video, see how to dismantle and replace the front headlight bulb on a KTM Duke 690 in simple steps. First, remove the front headlight; to do this, unscrew all the securing screws found on the sides, as shown in the video.

At this point, disconnect the electrical connectors and remove the protective cap of the headlight bulb; unclip the metal spring to remove it, replacing it with the correct new one (in this case, a new LED bulb is installed). Finally, reassemble everything!


Updated on 27 April 2026 by ScegliAuto


Related tutorials

How to Replace the Front Headlight Bulb on a KTM Duke 690
How to Replace the Front Headlight Bulb on a KTM Duke 690
Duke 690 Today, let's briefly go over the steps needed to remove and replace the front headlight bulb on a KTM Duke 690, following these simple steps. First, …
Replacing the Radiator of the KTM Duke 690
Replacing the Radiator of the KTM Duke 690
Duke 690 Today, we will see in this video tutorial how to remove and replace the cooling radiator of the KTM Duke 690 motorcycle. First, place the bike on its…
How to Replace the Brake and Clutch Levers on the KTM Duke 690
How to Replace the Brake and Clutch Levers on the KTM Duke 690
Duke 690 In today's tutorial video, you will see the steps to remove and replace the brake and clutch levers on the KTM Duke 690 motorcycle. First, place your…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos