Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove the front shield of the Kymco Agility

Model: Kymco Agility 125
Part:

Video tutorial

In this video, we will see how to change or remove the front shield of the Kymco Agility: first, we need to remove the three screws that we find by looking inside the wheel arch, then we can remove the two expansion pins. From inside the shield, we can remove the visible screws.

Once the shield starts to move away from the bodywork, we will find other screws inside that we will need to remove as well. We must be very careful with the plastic tabs, which require a lot of attention and delicacy in moving them with a small screwdriver.

Then disconnect the turn signal connectors, and we can completely remove the shield.


Posted on 14 September 2025 by ScegliAuto


Related tutorials

How do you replace the front headlight bulb of the Kymco Agility 125?
How do you replace the front headlight bulb of the Kymco Agility 125?
Agility 125 In order to replace the headlight bulb of the Kymco Agility 125, you need to loosen the screws that secure the front fairing to its seat: by doing so…
How to Replace the Front Headlight Bulb on a Kymco Agility Scooter?
How to Replace the Front Headlight Bulb on a Kymco Agility Scooter?
Agility 125 As shown in this tutorial, replacing the front headlight bulb on a Kymco Agility scooter is an extremely simple and quick task. First, ensure that th…
Replacing the Front Headlight Bulb on a Kymco Agility 125
Replacing the Front Headlight Bulb on a Kymco Agility 125
Agility 125 In this video tutorial, see how to remove and replace the front headlight bulb on a 2014 Kymco Agility 125 scooter in simple steps. First, remove all…

How to replace the transmission oil in the KTM Exc 300

Today, let's discover how to carry out the routine maintenance service by replacing the transmission oil in the two-stroke enduro bike KTM Exc 300. First, place your bike on a stand and start by unscrewing the oil drain bolt located under the engine, allowing the gearbox oil to drain into a container for about ten minutes; then clean the small mesh oil filter, as shown in the video. At this point, unscrew the filler cap and top up with the new gearbox oil, the specifications of which are indicated in the owner's manual!

Watch the video!


by ScegliAuto

More videos