Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kymco Xciting 500
Part:

This guide provides the main instructions for removing and replacing the belt and variator of the Kymco Xciting 500 scooter. First, place the scooter on its centre stand and begin unscrewing the fastening screws of the transmission cover to remove it; then unscrew the nuts of the fan and bell to take them off, as shown in the video. At this point, remove the belt and subsequently the variator, replacing them with new ones if necessary; finally, reassemble everything by applying the reverse procedure of disassembly!

Updated on 22 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Belt on a Kymco Xciting 500
How to Replace the Belt on a Kymco Xciting 500
Xciting 500 Below are the steps to remove and replace the drive belt on the Kymco Xciting 500 scooter, in simple and quick steps. First, place the scooter on its…
Service and Repair Manual for the Kymco Xciting 250-500
Service and Repair Manual for the Kymco Xciting 250-500
Xciting 500 In this video, the repair manual for the Kymco Xciting 250-500 is presented. This essential workshop document contains general technical specificatio…
How to Replace the Spark Plug on the Kymco Xciting 500
How to Replace the Spark Plug on the Kymco Xciting 500
Xciting 500 Follow this guide for instructions on how to remove and replace the spark plug on the Kymco Xciting 500 scooter by following these simple steps. Firs…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos