|
Do it yourself
| |||
| ||||
|
Model: Kymco Xciting 500
Below are the steps to remove and replace the drive belt on the Kymco Xciting 500 scooter, in simple and quick steps. First, place the scooter on its centre stand and begin unscrewing the fastening screws of the transmission cover on the left; once removed, you can unscrew the fan nut, then remove the drive belt. At this point, install the belt in the correct direction, then reassemble the fan and the transmission cover, applying the reverse procedure of disassembly!
Updated on 25 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Xciting 500
This guide provides the main instructions for removing and replacing the belt and variator of the Kymco Xciting 500 scooter. First, place the scooter…
Xciting 500
Follow this guide for instructions on how to remove and replace the spark plug on the Kymco Xciting 500 scooter by following these simple steps. Firs…
Xciting 500
To replace the air filter of the Kymco Xciting 500, open the under-seat compartment by turning the appropriate key in the lock. Once the seat is lift…
|
How to replace the coolant in the BMW S1000 R
Today, we will see in this video tutorial how to bleed and replace the coolant in the BMW S1000 R motorcycle. First, place your motorcycle on a stand and start unscrewing the bleed screw located on the water pump casing, found at the bottom right; let the fluid drain into a container for about ten minutes. Now, unscrew the radiator cap and top up with the new coolant, the correct type for your radiator; fill it to the maximum level mark, starting the engine to circulate the fluid! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.199
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |