Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Defender
    4. : How to remove the stock car stereo

Land Rover Defender - Video tutorial

Model: Land Rover Defender MK 5 - Years 1983-1990
Part: Car stereo
Operation: How to remove the stock car stereo

In this short video we are going to see how to remove a stock car stereo. The only thing we need are two release keys (be careful because it can happen that a car radio requires its specific keys, the latter are not universal). In this case, each release key is made up of two pointed ends that we are going to insert into the holes of the car radio. Once inserted, these will fit inside and at this point we will only have to pull everything towards us to extract the whole block. Finally we have to disconnect the various connections attached to the rear of the car stereo, including the antenna cable.


Posted on 24 July 2023 by ScegliAuto



How do i remove the tank of the Land Rover Defender 90?
Land Rover Defender (1983-1990 / MK 5) In order to replace the tank of the Land Rover Defender 90 you have to go to access the lower part of the car, at the rear left wheel. Here, near the
How to remove the anti-roll bar on Land Rover Defender
Land Rover Defender (1983-1990 / MK 5) Let's see how the anti-roll bar of the Land Rover Defender is removed. We place our car on a column bridge, we lift to a comfortable height to interv
How to reset the service in a Land Rover Defender 2.2
Land Rover Defender (1990-2016 / MK 6) In this video tutorial we can see how it is possible to reset the service in a Land Rover Defender 2.2, through simple steps that will help you manag

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos