Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Discovery
    4. : How to connect the Land Rover Discovery towbar electronics

Land Rover Discovery - Video tutorial

Model: Land Rover Discovery MK 4, LR4, Discovery 4 - Years 2010-2016
Operation: How to connect the Land Rover Discovery towbar electronics

Let's see in this short guide the instructions on how to connect the electronic part of the tow hook, as well as how to install it on the car, of the Land Rover Discovery. First we open the tailgate of the trunk and start by removing the taillights; then we pass the tow hook wiring to connect it to the existing wires of the rear bulbs, as shown in the video. At this point we make any changes necessary for the operation of the trailer lights; we remind you to install approved tow hooks only.


Posted on 9 April 2024 by ScegliAuto

    Frequently Asked Questions

    • Discovery 2010-2016 - What are the most common problems of the Discovery 4? Read Answer
    • Discovery 2017-2023 - Why is my Land Rover Discovery's Smart Start & Stop not working properly? Read Answer
    • Discovery 2010-2016 - Problems encountered on the Land Rover Discovery sport? Read Answer
    • Discovery 2010-2016 - What problems does Land Rover Discovery IV have? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos