Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Lexus
    3. : SC

Lexus SC - Videoguide

Lexus SC (2001-2010 / Z40)
To reset the maintenance light on the Lexus SC 430.
In the following mini guide dedicated to your 2009 Lexus SC 430, we will explain how to correctly perform a manual reset of the maintenance indicator that …read all…
Posted on 26 July 2023 by ScegliAuto
Lexus SC (2001-2010 / Z40)
How do you reset the tire pressure warning light on the Lexus SC430?
In order to reset the Lexus SC430 tire pressure warning light, you have to unplug the connectors of the tire pressure sensors. To do this, you must go and …read all…
Posted on 11 July 2022 by ScegliAuto
Lexus SC (1991-2010 / )
Navigator display disassembly instructions
The navigator display is located right in the center of the dashboard console, immediately above the climate control controls: however, in order to remove it, …read all…
Posted on 31 August 2023 by ScegliAuto
Lexus SC (1991-2010 / )
Car radio disassembly instructions
Before proceeding with the disassembly of the car radio, it is advisable to pull the handbrake and move the gear lever backwards to have more room for …read all…
Posted on 29 July 2023 by ScegliAuto
Lexus SC (1991-2010 / )
Iphone, ipod and aux kit installation
This video shows us how to install an iphone, ipod and aux interface kit. First we go to remove the piece of dashboard installed by pressure and positioned …read all…
Posted on 26 July 2023 by ScegliAuto
Air conditioning (1) Car stereo (1) Checks and maintenance (1) Accessory Kit (1) Instrument cluster (1)

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos