Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing LED Lights in Your Car

Model: Lexus GS - Years 1997-2004
Part: Accessory kit

The term LED stands for "Light Emitting Diode." Essentially, LEDs are small, inexpensive lights that come in various colours and can be turned on and off intermittently. They are an excellent solution at a low cost for decorating and personalising the interior of cars. Installing LEDs in vehicles requires minimal time and effort. You will need to obtain a number of LEDs in your preferred colours, as well as a tool to transport them, a soldering iron, two electric wires about 20 centimetres long, a small switch, and solder. At this point, you can insert the lights you have purchased. Then, take the wires, strip one end, and proceed with the soldering.

Updated on 22 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installation of Adapter Kit to Control iPhone via Stereo
Installation of Adapter Kit to Control iPhone via Stereo
Lexus GS (2005-2011 / S190) If you want to control your iPhone through the stereo, you can do so by installing one of these kits. First, use a hook tool to remove the panel belo…
Instructions for Removing the Car Radio
Instructions for Removing the Car Radio
Lexus GS (2005-2011 / S190) Removing the original car radio requires the removal of some trim elements from the centre console: start by unscrewing the gear lever knob after pos…
Replacing the Front Headlamp Bulb
Replacing the Front Headlamp Bulb
Lexus GS (1997-2004 / ) It can happen that the bulb in your car burns out, and in that case, it needs to be replaced. If you want to save money on an auto electrician, you c…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos