Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Lml Star
Part:

In this tutorial, we will see how to remove the electronic ignition, specifically the flywheel (or rotor) and stator, on an LML Star 125-150-200, as well as on a Piaggio Vespa PX. First, unscrew the central nut of the flywheel using a socket wrench; then use a puller to remove the flywheel, as shown in the video. Next, unscrew the mounting screws of the stator, disconnecting the electrical wires; then simply slide it out of its seat. For reassembling the ignition, just apply the reverse procedure!

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Stator of the LML Star?
How to Replace the Stator of the LML Star?
Star To remove the stator of the LML Star, you need to completely disassemble the engine and transmission unit, removing it from its housing. On its side,…
How to Remove the Stator from the LML Star?
How to Remove the Stator from the LML Star?
Star To replace the stator on the LML Star, remove the right-hand engine cover by simply unfastening it. Underneath, there will be six bolts that need to …
How to Replace the Knobs on the LML Star?
How to Replace the Knobs on the LML Star?
Star To replace the knobs on the LML Star, remove the old ones by prising them off from the base, as there is a screw at the end that may break. Heat the …

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos