Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Malaguti
    3. : Blog 125
To remove the instrument cluster from the Malaguti Blog 125, loosen the screws securing the windscreen and remove it. Once the windscreen is removed, also take out its supports to access the two screws underneath. Next, remove the four bolts located under the knobs, two on each side. This will allow you to detach the entire front fairing, which houses the instrument cluster. To disconnect it from the bike, unplug the connector; after this operation, you can replace the removed parts.

Updated on 24 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Fuel Pump on the Malaguti Blog 125?
How to Replace the Fuel Pump on the Malaguti Blog 125?
Blog 125 To replace the fuel pump on the Malaguti Blog 125, open the seat and loosen the screws that secure the under-seat compartment. The screws are located…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos