Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace a Bulb on a Maruti Sx4

Model: Maruti Sx4 MK 1 - Years 2007-2014
Part: Headlight bulb

If you need to replace a burned-out bulb in the front headlight of your vehicle, you can find the instructions to follow in the description below and in the video. First, open the hood and locate the headlight that contains the bulb to be replaced. Then, disconnect the power connector located behind the bulb and unclip the steel clip to remove the bulb. Take the new bulb, being careful not to touch the glass with your fingers, and place it in the headlight housing. Then, reattach the steel clip and reconnect the power connector.

Updated on 16 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Engine Oil and Oil Filter Replacement for Maruti Sx4
Engine Oil and Oil Filter Replacement for Maruti Sx4
Maruti Sx4 (2007-2014 / MK 1) Follow these steps to perform routine maintenance by replacing the engine oil and oil filter on the Maruti Sx4. First, lift the vehicle and start dra…
How to Remove the Inner Door Panel of the Maruti SX4 Mk1
How to Remove the Inner Door Panel of the Maruti SX4 Mk1
Maruti Sx4 (2007-2014 / MK 1) This guide shows how to remove the inner door panel of the Maruti SX4 Mk1. The first step is to remove the plastic trim piece at the mirror attachmen…
Replacing the Fuel Filter on a Maruti Sx4
Replacing the Fuel Filter on a Maruti Sx4
Maruti Sx4 (2007-2014 / MK 1) In today's tutorial video, you will learn how to remove and replace the fuel filter on a Maruti Sx4, following the instructions below. First, open th…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos