Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Dismantling the Armrest

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Center console tunnel

The covering of the armrest tends to wear out due to constant friction with the elbow, sometimes even resulting in holes. You can replace it or have it reupholstered in leather (choosing a quality covering will last much longer than the original). In any case, you need to dismantle it. Start by opening and lifting the armrest, then remove the plate covering the base of the hinge and unscrew the underlying screws. Move to the back of the armrest and remove the other rear plate, completing the dismantling before proceeding in reverse for reinstallation.

Updated on 19 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Internal Door Handle
Removing the Internal Door Handle
Mazda Cx 7 (2006-2012 / MK 1) To remove the internal door handle, you must first take off the door trim panel: there are only two fixing screws, one inside the handle housing whic…
Instructions for Removing the Front Wheel Hub
Instructions for Removing the Front Wheel Hub
Mazda Cx 7 (2006-2012 / MK 1) If you hear a noise coming from the front wheel that increases especially in corners, the bearing at the centre of the hub is likely damaged: to repl…
Removal of External Rear-View Mirror
Removal of External Rear-View Mirror
Mazda Cx 7 (2006-2012 / MK 1) To remove the external rear-view mirror, first remove the door panel as the electric adjustment cable for the mirror passes through the panel to reac…

How to Remove the Timing Belt from a Nissan Juke

How do you remove the timing belt from a Nissan Juke? Raise the car on a column lift and remove the front wheel, using a screwdriver to detach the right wheel arch liner. Once these operations are complete: lift the bonnet, remove the engine soundproofing panel and the timing belt cover (from the wheel arch). Use a suitable spanner to loosen the tensioner pulley and slide the belt off its seat. After fitting the new belt, use the spanner to tension the tensioner pulley, adjusting until the correct tension is achieved on the belt (previously fitted). Finally, check the tensioner and the belt itself, tightening everything with a socket spanner.

Watch the video!


by ScegliAuto

More videos