Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Front Wheel Hub

Model: Mazda Cx 7 MK 1 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Bearing

Video tutorial

If you hear a noise coming from the front wheel that increases especially in corners, the bearing at the centre of the hub is likely damaged: to replace it, you must remove the wheel hub itself and then use a press for the extraction and insertion of the bearing; lift the vehicle on suitable axle stands and remove the front wheel; take off the retaining nut of the driveshaft and the brake caliper complete with bracket; then remove the speed sensor and finish removing the ball joint of the suspension arm and the bolts securing the shock absorber to the hub support.


Updated on 18 February 2026 by ScegliAuto


Related tutorials

Instructions for Removing Front Shock Absorber
Instructions for Removing Front Shock Absorber
Mazda Cx 7 (2006-2012 / MK 1) To remove the front shock absorber, it is advisable to lift the vehicle on a ramp, but using axle stands will also suffice. Once the vehicle is raise…
Instructions for Replacing the Driveshaft
Instructions for Replacing the Driveshaft
Mazda Cx 7 (2006-2012 / MK 1) If you hear a noise like a CLUNK coming from the wheel, especially when steering, it means that a CV joint of the driveshaft connecting the gearbox t…
Removal and Reinstallation of Brake Discs
Removal and Reinstallation of Brake Discs
Mazda Cx 7 (2006-2012 / MK 1) To remove the front brake discs, start by lifting the vehicle on appropriate car stands. Remove the wheel and use a lever between the disc and the ca…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos