|
Do it yourself
| |||
| ||||
How to Remove the Navigation System and Central Air Vents on Mercedes A-Class W 176
Model: Mercedes Classe A
W176
- Years:
2012, 2013, 2014, 2015, 2016, 2017, 2018
Video tutorial
Removing the display of the radio and navigation system of the third generation Mercedes A-Class (chassis W 176) is very simple: the display looks like a real tablet, located in the center of the dashboard; at the back of the display, there are two caps that, when opened, provide access to the two mounting screws; once the screws are removed, slide the display upward to detach it, and finally disconnect the power connector and GPS antenna; then detach the trim around the support and unscrew the mounting screws of the support itself; to detach and remove the air vents, it is recommended to use an electrical wire to insert and fold inside the vent to pull and release it.
Updated on 20 March 2026 by ScegliAuto
Related tutorials
Mercedes Classe A
(2012-2018 /
W176)
Today's instructions will show you how to use the navigation system on the Mercedes A-Class. First, get in the vehicle and turn on the instrument clu…
Mercedes Classe A
(2012-2018 /
W176)
Is the radio in your Mercedes A-Class to be replaced? Here’s how to remove it from above the dashboard. To remove the radio, you need to take out the…
Mercedes Classe A
(2012-2018 /
W176)
Let's see how to update or use the Becker Map Pilot navigation system in a Mercedes A-Class. This is a very simple operation: enter the vehicle, turn…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in
|
Adjusting the Handbrake on a Kia Sportage
Today, learn how to adjust the handbrake on a Kia Sportage (2016-2022). Start by opening the armrest and removing the bottom with a small flat screwdriver as shown in the video. Next, remove the inner panel on the handbrake side to access its adjustment nut. Once done, use a spanner to turn the nut clockwise to increase the handbrake tension, or alternatively, loosen the tension by turning the nut anti-clockwise. After adjusting the cable tension, reassemble everything by following the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.030
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |