Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : Disassembly of the car radio for KIit iPOD installation

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W203 - Years 2000-2007
Part: Accessory Kit
Operation: Disassembly of the car radio for KIit iPOD installation

Using a plastic tool to avoid damaging the body, pry the base of the tunnel around the gearbox to release the plastic clips and move it to access the radio console retaining screws. Slide off the complete console and remove the electrical wiring connectors needed to install the kit. Prepare the two cables supplied with the kit and insert them into the original connectors and the other end insert them into the kit control unit. The control unit must be connected in series to the power supply cable to the audio aux input. Program the kit box according to the instructions attached to the kit and fix it inside the dashboard by removing the plastic cover on the passenger side. The second box equipped with the connectors must be fixed, in an accessible way, under the dashboard with the supplied screws. Refit the cover by passing the cables through the radio tunnel. Reassemble the radio by proceeding with the reverse operations.


Posted on 18 July 2023 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos