Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : Replacement of the MAF airflow sensor

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W202 - Years 1993-2000
Part: Engine
Operation: Replacement of the MAF airflow sensor

The MAF sensor has the task of measuring the amount of air flowing into the engine through the air intake. The sensor is located in the air intake pipe extending from the fuel injection system filter. If this sensor is defective it must be replaced. All you need is a new sensor, a screwdriver and a socket wrench. The MAF sensor is located inside the filter box, you will need to remove the air box cover and take out the air filter, then loosen the clamps on the inlet pipe with a screwdriver and pull the intake pipe from the box. air. To install the new sensor, proceed in reverse order.


Posted on 16 August 2023 by ScegliAuto

    Frequently Asked Questions

    • Classe C 2007-2013 - What engine does the Mercedes C-Class have? Read Answer
    • Classe C 2014-2021 - What problems does the engine of the Mercedes C-Class present? Read Answer
    • Classe C 2014-2021 - What problems does the engine of the Mercedes C220 CDi have? Read Answer
    • Classe C 2014-2021 - What is the cost of maintenance service B on the Mercedes C-Class? Read Answer
    • Classe C 2007-2013 - What role does the crankshaft position sensor play? Read Answer
    • Classe C 2000-2007 - How much does it cost to redo the engine of the Mercedes C220? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos