Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : Replacement of the cabin air filter for the Mercedes C-Class.

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W205 - Years 2014-2021
Part: Cabin air filter
Operation: Replacement of the cabin air filter for the Mercedes C-Class.

On the intake side of the air conditioning system of the Mercedes C-Class, a filter is installed to prevent dust from entering the circulation. It needs to be replaced periodically to ensure clean air at all times. To do this, position yourself in the front passenger seat, unscrew the two screws holding the partition under the glove compartment, detach the sensor and disconnect the electrical connector attached to it. Open the cover of the filter box, remove it and replace it with a new one, close the cover, connect the connector and position the sensor, reposition the panel and secure it with its screws.


Posted on 9 December 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Classe C 2007-2013 - Where is the cabin air filter of the 2013 Mercedes C220 CDI coupe located? Read Answer
    • Classe C 2007-2013 - How much does the Mercedes C-Class 220 cabin air filter cost? Read Answer
    • Classe C 2007-2013 - Where is the air conditioning filter of the Mercedes CW 204 class? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos